home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Libris Britannia 4
/
science library(b).zip
/
science library(b)
/
HAM_RAD
/
3176.ZIP
/
ICOM1.ZIP
/
IC02AT.10
< prev
next >
Wrap
Text File
|
1990-09-05
|
1KB
|
25 lines
IC02AT.10
7. Carefully apply power to radio and enter the lowest desired frequency.
8. Adjust slug through bottom hole on VCO cover for .5 VDC at VCO test
point (just below VCO shield) at lowest desired operating frequency.
9. This completes the modification. A few words of caution: 1. The
radio is not type accepted for use in the commercial band. 2. Make
sure you reinstall the battery latch correctly on bottom of radio or
battery will become permanently locked onto radio. 3. Tighten screws
on bottom of radio snuggly. If they loosen while battery is connected
you cannot remove the battery. (This has happened to many units and
it would be prudent to periodically check these screws to assure their
tightness.)
------------------------------------
***->Be careful not to transmit out-of-band, or accidentally operate on
any non-amateur, unless you are authorized to do so.
DO NOT JEOPARDIZE YOUR LICENSE!
RELAYED BY...N0KGX...GENE